Among Us Transforming Crewmate/Impostor

Print everything without supports in its given orientation except bone_print_with_supports.stl. You can superglue bone_print_with_supports.stl to jaw_upper.stl. Cut 1.75mm filament to use as a pin to hold jaw_upper.stl and jaw_lower.stl together.https://www.youtube.com/watch?v=6aXmk-A7hyoNote that the bone is not supposed to spin internally despite the backpack being turned 180 degrees. THE BONE IS ALWAYS UPRIGHT. In Crewmate mode, the backpack locks the bone+jaw assembly to the bottom half, so when you lift the upper half the bone does not follow. In Impostor mode, the bone is still inside the helmet/upper half, just that the backpack locks the bone+jaw assembly to the upper half.Note that jaw_upper.stl is not supposed to rotate when you rotate the backpack_upper.stl. If it does, you might have to sand down the pin in jaw_upper.stl.Update 17 Nov 2020:jaw_lower_soft.stl and jaw_upper_soft.stl added for soft-tipped teeth. backpack_lower_snap.stl and backpack_upper_snap.stl added for a tighter backpack which clicks together.