2nd Generation Chevrolet Chevy Silverado phone holder 2007-2013

V3 Moved the phone farther out and angled/tilted it up/back at 75 degrees (or leans back 15 degrees). I removed the bracing and printed in PETG and it's been working fine.

Added Fusion 360 files (f3d, 3mf, stl).

V1 Designed to fit the passenger-side cubby but at a 45* angle to face the driver.

It uses the two holes for the rubber mat that fits in there to hold it in place, wedging against the top in the back.

I measured for an iPhone 13 with a case: 79mm wide, 13.5mm deep, and 75mm tall supports. Charging port is 13.5mm X 6.5mm, offset slightly towards the front.

This is an original design I made, and the bracing is way overkill, but I printed in PLA and am hoping it'll keep it from warping too bad in the South Texas heat.

Print Settings

Printer Brand:

ELEGOO

Printer:

**Rafts:**

No

Supports:

**Infill:**

50%

Filament: Polymaker PETG yellow

Notes:

0.4mm nozzle
0.4mm line width
0.32mm layer height

How I Designed This

Used the rubber mat that fits in the cubby as the base for measurements to line up the holes & dimensions. Used a digital caliper to take measurements, then printed a few 1mm thick bases to check fitment.

Extended it out past the cubby and angled it 45to face the driver, tilted phone upwards 15 for better viewing.

I measured it to fit an iPhone 13 with a case.

Category: Automotive