September 10, 2024
Description
Quite simple yet very cool pot/planter with a nice patern on the outside.
Prints well in PLA/PETG, but should print well using any material on any printer (I Think)
No supports are needed, infill of 8-10% should be sufficient.
In the example pictures I used the Polymaker Polyterra PLA Banana filament.
At 100% the planter is 11 centimetres high, and the hole diameter is approximately 9 cm wide. Scaling the model should not be a problem.
License:
Creative Commons — Attribution — Noncommercial
TheRepairrot
