September 16, 2024
Description
These models are statues that belong in our St. Mark's Bell Tower model, and are a separate publication because they are remixed from third-party existing models, and we are respecting their original license. Â If you are building the assembly of the bell tower, please print these too and add them where indicated further below.
The belfry is topped by an attic with effigies of the Lion of St Mark and allegorical figures of Venice as Justice. The tower is capped by a pyramidal spire at the top of which there is a golden weather vane in the form of the archangel Gabriel (from Wikipedia).
These models were made by Dany Sánchez by remixing the following existing sources:
Sources from ScanTheWorld and DutchMogul on MyMiniFactory
License CC 4.0 https://creativecommons.org/licenses/by-nc-sa/4.0/
Â
Print these in order to complete your assembly of St. Mark's Bell Tower (Campanile di San Marco) in Venice!
Â
If you like our work, consider joining our Printables Club for monthly exclusive models!
We are also on Patreon!
patreon.com/MiniWorld3D
Find all our profiles, YouTube channel & social media on:
Follow us on IG!
MiniWorld 3D is a collective of 60+ artists creating the best library of 3D printable models of landmarks of the world!
Photo credits: by Dany Sánchez in a Prusa MK4 with Fillamentum turkey egg PLA, Amolen brick, 3D Hojor silk gold PLA.Â
Â
-----------
No supports needed, this has been optimized to eliminate all overhangs.
Suggested parameters:
Without input shaper, print slow for better details: 15 or 20mm/s for outer perimeters.
Fine-tune retraction to avoid stringing.
Perimeters: 2
Top layers: 3
Infill: as low as 12%, lightning pattern ok.
Print the Justice and Lion panels flat on the bed, and you can use pause-and-filament change to start with brick, then to marble at the right height.Â
The Archangel could use a brim or raft to ensure a good adhesion.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
MiniWorld3D
