Simple GateMate CCGM1A1/A2/A4 Evaluation Board & Programmer Case

A little case for the Cologne Chip GateMate CCGM1A1/A2/A4 Evaluation Boards and Programmers from the GateMate FPGA Starter Kit.

The evaluation board sits snugly in the case itself and is held down by additional screws. The original rubber feet can be reused for the case.

The programmer PCB is screwed in from the back, you can either use new M2.5x6mm screws or reuse two of the original screws to mount the case.

Recommended Material & Print Settings

• Nearly every Material should work, Test prints were done in PLA.
• No supports needed.
• Two (or more) perimeters recommended for the screw pegs to be solid enough

Additional Hardware

• 4x M3x10 DIN 912 Cylinder Screws (between 8 and 10mm should be fine)
• 4x M3 Heat Set Inserts (CNC Kitchen ones tested, others may work as well)
   
• 4x M2.5x6 screws (you can use two of the boards from the programmer itself if you don't have any on hand)

Compatible Boards

• CCGM1A1/A2/A4 Evaluation Board
• GateMate FPGA Programmer Board

Please consider liking the model and posting a Make :)