RGB Headphone Stand /Headphone Holder

You will need     Arduino nano 

                             ws2812b Ledstip about 20cm/8in

                             long Tactile  button min. 6mm

                             (or you can use 3d printed Optional button )

                            Few cables 

                            5v usb male conector (you can use cable with male                                                                           connector from old charger)

Assembly :  step 1 : first you need to solder cables to ledstrip and then stick the ledstrip to the                                     base  (run the cables through the hole)        

                     step 2 : connect cables and program the arduino nano (use the youtube video as a                                    guide , start at 5min. But instead of conecting stepdown modul , connect                                      usb cable to arduino ) 

                     step 3 : Screw Arm to the Top part using M4x10 (PS : if you printed Top as                                                  separate parts you need to superglue them together )

                     step 4 : superglue Base and Top assembly together (make sure the arduino and                                          cables stick out from bottom hole)

                     step 5 : drill 5mm hole in the top mesh to fit the button and then glue the button                                      from bottom to the hole (I didn´t have long tactile button so i printed                                              button extender, you can find it in the models)       

If you would need some help you can ask me in the coments.