Gridfinity SMD tape organizer

Update 2024/10/20: I've updated the 5x1 base so it can hold an extra container for a total of 18. I also added 1, 2, 3 and 4-unit wide variants which can hold 3/4*, 7, 11 and 14 containers respectively.

*There are 2 variants of the 1-unit base. Since 1 unit is 41.5mm wide it just fits 4 containers. However, that leaves no room for dividers, which may make the base hard to print due to the overhangs. So I included 2 versions: One with dividers that can hold 3 containers, and one with only side-walls that can hold 4. 

Disclaimer: I have not printed any of these updated models yet. All relevant dimensions are the same, so they should work just fine, but I'm just like R2-D2 in that I am known to make mistakes from time to time, so no 100% guarantee.

The SMD tape container clicks onto the base and the base holds 17 containers at once. This model is a remix of the excellent design by @MattWilde_295702. 

My containers are slightly larger (33.5x38.5 mm instead of 30x35 mm) to better match the Gridfinity grid-size and to make the top surface large enough to fit the smallest label my label-maker can print. The base was modified to match the new dimensions. Since the fixed grid size does not exactly fit a whole number of these containers I also added thin dividers between the container slots which makes them just a little bit easier to take out and replace.