Wall Mounted Toothbrush Holder

Print-in-Place wall-mounted toothbrush holder, and some small test pieces for you to make sure it all works before wasting filament on the full thing. It has a little folding cover to keep dust from settling on your toothbrush, which also doubles as a shelf.

In a large household, I've seen toothbrush holders that get pretty horrifyingly gross. Especially the roughly cup shaped ones. Lots of dark places for moisture to collect, lots of people with different schedules so it never fully dries out, etc. I wanted one that made as little contact with the actual brush as possible, and had little to no space for water to collect. This is my attempt at that, hopefully it works ok.

The hinge might need to be worn in a teeny bit but works fine for me. The holder has just enough give to snap a toothbrush in or out, even with standard rigid PLA.

Print Settings

Printer Brand:

UltiMaker

Printer:

**Rafts:**

No

Supports:

**Resolution:**

0.15

Infill:

**Filament:** Reflow rPLA Limoncello

Notes:

Post-Printing =============

Work the hinge back and forth a bit, should unstick easily enough. A little lube might help too.

Category: Bathroom