March 18, 2025
Description
Dock for holding the DF500 up, to the MFT3 table aluminium profile.
Slide the dock then use 2 T-Nut from the festool@ mft accessories, 2 m5 nuts and 5x20mm bolts to hold the dock to the MFT table rail.
The DF500 slides and is held tight by gravity and the pins from the execellent Izo@'s holder.
No clamps needed: there is a little flex, it does not impact operation. Clamps can be used to remove the flex:
License:
Creative Commons — Attribution — Noncommercial — Share Alike
8
gwendal
