Pressure transducer holder for Edwards TruWave

Edwards' TruWave invasive pressure transducer holder. It replaces the standard TruClip holder (item TCLIP05 from the Edwards catalog). Available in versions for one or two transducers.

For assembly, I used a 1/4 and 2-inch French screw (carriage bolt) and a nut, as well as cyanoacrylate glue for the handle.

As a bonus, I added a small hole on the left side of the holder that is exactly at the same level as the electronic pressure sensor. This way, you can look through this hole to check if the transducer is properly aligned with the patient's phlebostatic axis.

Printed with Creality Hyper filament on the Creality K1 printer, with 30% infill. No supports are required. Do not overtighten the screw because it can bend the structure.