This is a simple, but effective adjustable parking assist. It is easy to assemble and install. It is mostly 3d printed, but dose requires some extra hardware.
Parts
Ceiling bracket (included)
Ball (included)
Stopper (included)
Rope tensioner (included)
Drywall anchors (2x) (not included)
Screws (2x) (shaft must be smaller than 10 mm in diameter) (not included)
Paracord (the length depends on the height of your ceiling) (not included)
Print Instructions
Material: PLA or PETG
Supports: No
Orientation: Print everything with its bottom facing the build plate
Assembly (as shown in photos)
Step 1
Cut your paracord to length (the paracord needs to be 1.5 to 2 times the distance from your ceiling to the point you want your parking assist to hang to)
Thread one end of the paracord through the ball
Then thread the same end through the stopper
Tie an overhand knot on that end of the para cord to stop it from sliding out
Step 2
Thread the other end of the paracord through one of the holes on either end of the rope tensioner
Then thread the rope into the middle hole of the rope tensioner
Thread the rope through the ceiling bracket
Pass the paracord through the last hole in the rope tensioner
Tying overhand knot in the para cord to stop it from sliding out of the rope tensioner
Step 3
Place the ceiling bracket on the ceiling where you would like your parking assist to hang from
Well you hold the ceiling bracket in place, push your screws through the holes in the ceiling bracket to make indents in the drywall
Screw your drywall anchors into the ceiling, using the indents that you made in the drywall as a guide
Screw the ceiling bracket into the ceiling using the drywall anchors
Adjust your parking assist to the correct height
If you enjoy this model, please leave a like and a comment. Please contact me if you have any questions, concerns, or problems.
Devise3D
