September 26, 2024
Description
I needed somewhere to store my Artika Edwin remote, so it wouldn't be lost, so I created This!
Product Used
Buy Links:
Instructions
I printed this in Pla plus at 100% infill and 0.15 mm layer height.
I put 100% rectilinear infill in Prusa Slicer to ensure the clips of the mount printed sturdy. I also put supports on build plate only and no brim.
Installation
Use wood screws to screw the mount into place in a wall and test it by putting the remote into the mount, it should slide in and out of place.
Thank You and happy Creating!
License:
Creative Commons — Attribution — Noncommercial — Share Alike
ZOHOZ
