Illuminati pyramid container (2-piece print)

A mysterious illuminati pyramid with a storage compartment. Easily remove the lid and store all your thingamabobs inside.

This is a 2-part print:

• The lid / top of the pyramid
• The bottom / container part of the pyramid

Printing instructions:

• Print at 0.2mm layer height
• Printing in PLA is recommended but PETG should work just fine as well
• No supports needed for the bottom of the pyramid
• No supports needed for the lid. Just make sure the bridges are printed at a 45 degree angle
• Be aware that the tolerance of the lid is designed for the model to be printed at the original scale. If you scale the model the tolerance will change and you might not be able to fit the lid on top of the pyramid