Drip Caddy for HeyGears Reflex RS

Check out the new version!  https://www.printables.com/model/1046454-drip-caddy-v2-for-heygears-reflex-rs

The Reflex RS's flat build plate really holds onto resin.  I didn't really like any of the options HeyGears provides.  They were all kinda bulky, touched resin, weren't permanent, you couldn't close the lid, etc.  And they were hard to print on FDM without a ton of supports. (I don't want to waste that expensive resin on a large functional part 🙂 )

So I made this one.  It mounts to the side of the build plate using M4x12 screws.  There are some pre-tapped holes there already.  I had those screws lying around from my XL but these should work too: https://amzn.to/4eGBI8k (affiliate link).  You can use longer but you will need to print some spacers.

Can be left on while printing.

Prints without supports.  

I used PETG.  Can be printed in resin too.

------------  Change log  ----------------------------------

10/21/24: Added V3 version.  This fixes the issue where the caddy can touch the lid when z-axis is completely raised.  Added a notch so that the caddy can be locked in place.  Adjusted the plate angle for better draining.  Added a short version.