Halloween Pumpkin Mimic Box

Halloween Pumpkin Mimic Box

Here is my new project, the Halloween Pumpkin Mimic Box, scare your friends during the Halloween party and have fun together. 😁🎃

If you like this new project and what I post, please consider supporting me by leaving a like and a comment.

The making of this project was quite complicated, after several attempts gone wrong, I decided to make the button in such a way that it could be replaced. 
Initially I threw out 2/3 4-hour prints because I had made the button attached to the front face of the box, instead designing it detachable brought its benefits while also improving the mechanism during closing.

Assembly guide

Below is the guide to assemble the mimic box but if you prefer I have also added a pdf in the appropriate section for more convenience.

As already written in the guide, to connect the box to the lid you will need a 1.75 piece of filament, I did not use heat to clamp the ends as I did not think it was necessary.

Conclusion

If you like, please leave me a like and a comment with what you like or would like to improve, I will listen to any suggestions. 
I salute you and thank you for your support. 🤖🚀