Dehydrator Extension 75mm w/ Thermometer/Hygrometer Mount

I got a cheap food dehydrator from Amazon to dry filament. I didn't want to destroy the trays in case I ever want to actually dehydrate food. I printed a model off here that was supposed to be for the same model. It didn't quite fit. It's likely that the supplier changes over time to keep the cost down.

If you use this, I would recommend slicing off a small ring to test first.

This is 75mm above the inner lip. This seemed about the right height to accommodate 1 roll of filament with a little room. These will nest together if you want to dry multiple rolls at a time.

The lip inset is at 45 degrees and shouldn't need supports.

There are two version. One is just the extension. One has a spot to mount the round thermometer/hygrometers.

Non-affiliate links: 

Dehydrator: https://a.co/d/7nXKGf0 

Thermometer/Hygrometer: https://a.co/d/eswdycE

Print Settings

Printer Brand:

Creality

Printer: 

Ender-3 Max

**Rafts:**

No

Supports: 

No

**Resolution:**

0.2

Infill: 

10%

**Filament:** Sunlu PETG Black

Category: 3D Printer Accessories