Pavo Pico Walksnail Avatar Canopy

Designed to be easy to print with no supports or brim. Print at 90-100% infill with PLA+.

You'll want the gummies in your unit. I found the easiest way was to use fine point tweezers to start them in the holes and then your fingers to finish.

The camera mount is for the LITE version of the Walksnail Avatar 1s and friction fits, give it a good push on there.

When mounting the canopy to the Pavo Pico be mindful to not pinch the motor wires on the underside of the quad with the head of your screws.

If you haven't already done so I also recommend using e6000 to glue down your mipi cables and antennas' u.lf. You'll want to get the e6000 under the metal jacket of the antenna connector to prevent it from shorting something out on your Avatar Unit. Don't worry e6000 is very forgiving when dried and will pick right off, in a very satisfying way, if you mess up.

Lastly do not over-tighten your screws (2 finger tight here) when it meet the base and has a little force stop or you'll strip out the plastic.