Vertical Open Knife Holder Gridfinity box

About

I have Victorinox Swiss Army Knife with always open knife blade for easy access (and because I can't grow long enough fingernails :) ).  Recently I decided to have a decent place for it instead of keeping always open on the table.

I took 1x1x12 pmcquay bin and adjusted by fixing bottom holes for easier print, side holes for magnets, full infill box with a hole through-all box inside for the knife blade.
Entrance to the hole has some edges removed to make knife blade sliding in easier.

Please give a like and post makes and provide comments for further improvements.

Changelog
- 2025.06.08 added version with a bit more off-center hole where knife has more tools (photos with a black box and silver knife)
- 2024.11.01 initial release (photos with a yellow box and red knife)

Todo
- the hole entrance could have a bit of improvement for the knife tip on the shorter side.

Dimensions:

• width: 42mm (gridfinity)
• depth: 42mm (gridfinity)
• height: 12 units of gridfinity height, can hold over 7cm blade
• magnets 6x2mm, optional
• side holes 6mm diameter so you can put magnets from the side, you may need to use a drill to make it easier to put it in, also I suggest putting only 2 magnets from the shorter side, those magnets really help keeping knife in the box and give a slight friction when putting knife in/out

Print:

• notice gcode contains moves for my custom timelapse video capture (print head moves to back and then to Z axis), so provided gcode file is just for rough estimation of the print time + required filament,
• I suggest 0.2mm layer height
• infill whatever you like but 10% is enough
• no supports, no brim