Vuse Vapeholder

Hi 3D printing friends!  This is another holder design but made for the Vuse Vape to help organize your desk.  It is meant to hold 3 full devices, the right most spot is built to hold the charger (press fit), and the front 3 spots are for additional cartridges.  

Similar to my other design, it has a singular base and separate inserts so you can mix and match colors for a personalized design.  There are three types of inserts and all three are designed to just press into place (flush with base top).  You can use glue if desired, but shouldn't be needed.  The charger should press in from the bottom right up against the insert in that location. 

• Charging Spot Insert - Qty 1
• Full Device Insert - Qty 2
• Cartridge Insert - Qty 3

Recommended Settings (PLA): 

• 0.4 mm nozzle
• 0.2 layer height
• 10% infill (gyroid, base only)
• No supports
  • All holes facing upward for base.
  • Top finished edge facing downward for inserts.
• No raft or brim