VKB STECS Airbus Detents

I found it impossible to set up good Airbus style CLB + FLX/MCT + TOGA detents with the stock STECS detent pieces so I designed this custom piece that adds three identical and equally spaced detents.

Print with 0.2mm layer height and 100% infill. Make sure the model is oriented on its side with the little support lip facing down. Remove the support after printing. Install the detent all the way at the forward end of the detent frame. Calibrate the detents in the sim (Fenix MCDU, FBW FlyPad etc).

Be careful with the screw, I don't know how much you can tighten it before the countersunk head causes the layers to separate. It's probably tight enough if you can't move the detent with your thumb.