Info
Both designed for 8mm arrows.
I print arrowhead with 100% infill PLA and it works fine. For more durability, you can use etc. PETG, ABS.
Recommended usage:
- Use the extender as close to the tip as possible for maximum efficiency (picture 3, method 3). If you use method 2 from pic. 3, arrow will break after small shake. (I tested shoot with it, and it survived one shot. It broke in my hand after few seconds.)
- You can use tape for smooth transition between extender and arrow body or wrap the entire extender.
- IMPORTANT: I use super glue to connect two arrowheads, although you can wrap the entire extender in super glue for more durability -recommended.
If you do not follow the recommended usage, the extender is more likely to break as follow in picture 4.
Print Settings
Rafts: No
Supports: No
Resolution: 0,2
Infill: 100%
Filament: PLA/PETG/ABS
Category: Sport & Outdoors
DanZbo
