November 12, 2024
Description
This is the Super Stealth Orbiter, a super low profile mount/housing for your Orbiter 1.5 + voron stealthburner with easy access for servicing the Orbiter without removing it from the printer/housing.
To have an unbroken PTFE path from the exit of the orbiter directly down to the hot end.
No full loop in front of the Orbiter that prevents the idler door from fully opening.
A proper Bowden tube coupler.
Additional reinforcement, rigidity, ease of assembly, and overall long term durability compared to my intal release
A sleek look that gives little to no indication of the extruder being used. This includes removing the thumb wheel from the idler tensioner and instead simply using an m3 bolt. In my case I find I can still tension to the desired amount with just my fingers and the bolt. I also don't tend to adjust this much once its set.
(Ill add this soon, but nothing special. If you have some m3 hardware and heat sets from your build you are probably good to go.
Super Stealth Orbiter works with Orbiter 1.5 (I think that means the 1.0 should work too. Not sure.), the new MGN 12 based X-carriage (bolts go in from the front) and StealthBurner of course.
Assembly: Start building it. It will all make sense.
There is a version that uses a single square nut where the umbilical mount meets the SSO back (SSO + CAN Umbilical _ w Sq Nut) . If you have a square nut I would recomend this version. Otherwise the second version uses only inserts (SSO + CAN Umbilical).
This work is of course dervide from the Voron IP. Voron till I die! Open licens.
License:
GNU General Public License v3.0
8
Citywrecker
