November 15, 2024
Description
During assembly, I found that there was a small air gap around the middle hinge on 4 of the 12 flaps of the original design, due to the configuration of vent holes in some areas.
Rather than modify whole riser model after I had already printed it it out, I designed this plug to block individual holes.
This is intended to be printed in TPU (I used 95A). It is 2% oversized for a tight fit. Insert from the inside of the riser, as shown in the second photo.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
7
cliftoce
