Hexagonal screw box

I needed some organizer for a lot of screws and I liked hexagonal ones posted around on this site and/or thingiverse. Unfortunately they were mostly too small for my needs, so I designed my own.

As you can see in photos it can hold quite big amount of small screws.

Printed in PETG, 0.2mm layer height.

Lid is a little tight at the beginning, start opening/closing it on one side and progresively get to the other side. After a few tries it gets easier, but it stays firm. Alternatively you can brush the lid's edges a little, but be careful not to overdoing it.

Also it's best to print the Lid upside down, otherwise you will need a lot of supports or huge overhangs.

Enjoy :)