November 18, 2024
Description
Connector for adding ducted ventilation to your Bambulab P1S enclosure.
Once printed, glue neodymium magnets into the 4 slots on the back.
Screw in two M2 screws into the alignment holes. These don't screw into the enclosure, but just slot into the existing 2 holes in the enclosure back panel. Good for aligning nicely.
The screws should be 6-8mm long.
The connector attaches to 4 inch ventilation ducting. It's designed with a small ridge so the ducting doesn't slip off. Secure the ducting with cable ties. You can ‘chain’ cable ties together to get a long enough tie to fit all the way around the 4 inch ducting.
Print Settings:
License:
Creative Commons — Attribution — Noncommercial
7
Maker Mike
