November 17, 2019
Description
The RPS-320-24 is delivering a lot of power, but the original fan was just too noisy.
So I choose a Low noise fan NF 6*25.
But due to his width of 25mm, it must be installed outside of the original frame, so I designed a new cover to install it.
This new cover is fitting the RSP-320-24, with the "Supply Cover" from https://www.thingiverse.com/thing:2863826.
Not tested for LRS-320-24 or other "Supply Covers", but some of them may be compatible.
Just print :
Meanwell cover
Fan protection
Fan grid .
I used PETG, but not sure this was needed.
Be carefull to place some supports to print the cover, as the 2 areas fitting inside the "Supply Cover", need them.
I used 3*M3x18mm screws to fix the fan protection to the cover.
License:
Creative Commons — Attribution — Noncommercial
7
Rouletabille
