The Hive - Hurricane Duct for V6 Hotend Remix

I was mesmerized by the design of The Hurricane duct by @TheSniper because it was simple enough to be printed without supports and was easy enough to print without any issues right from the first try. However, I spotted two things that I would really like to change. 1 being that I wanted the ducts themselves to be a bit closer to the tip of the hotend, and 2 being that the hotend fan mount instantly melted on the bottom because it makes contact or very close to making contact with the heater block of the v6 hotend.

My solution is the open that area up to a bit more flow. On top of that, I recommend you place a strip of metal duct tape on the bottom of the fan to move heat away from the plastic. I have had had this hotend printing for several weeks now with zero issues and my bridges are better than ever.

Huge thank you to @TheSniper for the original design!

NOTE: You will need to make an adjustment to your print's nozzle location in your slicer. Because this moves the nozzle to a slightly altered spot than stock, use the below numbers in the image to get yours back into the center of your print area.

Enjoy and post your makes!

If you found my Things useful, treat me to a cup of coffee by using the PayPal button below :) Buy me a cup of coffeeBuy me a cup of coffee $3.00 USDBuy me a massive cup of coffee $5.00 USDGive me a caffeine coma $10.00 USD Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

0.14

Infill:

45

Filament: Inland PLA Peak Green

Category: 3D Printer Accessories