3D printer enclosure

This enclosure was designed for Luxor BC45-B (or BC45-G) cart ( https://www.totallyfurniture.com/four-flat-shelf-black-utility-cart-luxor-bc45-b ) and it locks in place with the bottom block extensions.  The block extensions can rotate upwards so the enclosure will fit on a flat surface (like a table).

See https://www.prusaprinters.org/prints/109185-enclosure-handle if you want to add handles!

Update 27MAY23:

Drill patterns work with 3/32 plexiglass.  I added drill patterns to work with ¼ plexiglass that have “0.25THK” prefix.  I have not tested the ¼ patterns but they should work.

In addition to printed parts, you'll need:

(20) Hex bolts, Zinc plated steel, 1/4"-20 x 1-1/4"
https://www.boltdepot.com/Product-Details.aspx?product=196

(20) Hex nuts, Zinc plated steel, 1/4"-20
https://www.boltdepot.com/Product-Details.aspx?product=2648 

Clear Polycarbonate  (I used this: https://www.tapplastics.com/product/plastics/cut_to_size_plastic/polycarbonate_sheets/516 )

(1) "Top Plexiglass: ", 24, 18
(1) "Back Plexiglass: ", 24, 20
(1) "Front Plexiglass: ", 24, 20
(2) "Side Plexiglass: ", 17.814, 20

{The side panel width is 18" minus two panel thicknesses since it fits inside the front and back panels}

NOTE:  I used Polycarbonate but other 3/32" plastic will also work.  If you use a different thickness plastic, the drill patterns will not work.

Printed parts:

(20) bolt knobs ( https://www.prusaprinters.org/prints/78501-14-bolt-knob )

(4) top blocks

(4) bottom blocks

(1 set) side hole patterns

(1 set) hole patterns (for front, back, and top)

Assembly:

Before drilling, see the pictures, cutaway STL files (All of them say “DO_NOT_PRINT”).  Once you know where to drill, double check with the drill patterns to make sure the holes align. Clamps may help assembly, I used the large clamp from here: https://www.thingiverse.com/thing:1673030.  Once your ready, use the pilot hole patterns and a 3/32 drill bit, followed by a ¼" drill bit.

Ask if you have questions!