Dual device tripod mount

I have two Apurture MC lights but only a single tabletop tripod.

This object allows the mounting of two such lights (or devices with 1/4-20 mounts)
There are three parts to this object, the top, the bottom, and the dial.  A single top is needed, while two of the bottom and two of the dial are required.

The original mounting point for the adapter must be less than 52mm wide in order for this to fit properly.  This gives sufficient space for two of my lights to fit with a gap between them, but could be a factor depending on the dimensions of the devices being mounted.

Additionally, the following parts are required:

• one 1/4-20 hex head nut (a plain nut, not a locking or acorn nut)
• two 1/4-20 x 1/2inch hex head bolt
• eight m3-0.5x8mm hex socket cap screws
• eight m3x6x5 heat set inserts (m3 size, 6mm tall, 5mm outside diameter)
• some adhesive (CA glue and accelerator work great)

It should be obvious from the pictures which hardware goes where.

I'd recommend printing:

• the top part with the top facing down with supports
• the bottom parts (2 of them) with the flat side down, again with supports
• the dial parts (2 of them) with the hex opening up, without supports.

I made mine with Bambu Labs PETG-HF in black, with a 0.4mm nozzle, 0.2mm layer height, 5 walls, 4 top layers, 4 bottom layers, and 20% gyroid infill.