December 2, 2024
Description
It's fitting for horizontal door handle bars looking to the left/right .
Installation/removing: pull the ring part through the handle, you will figure it out :)
The DO NOT Enter sign is fixed with superglue to the top part.
There are two small aligning pins/holes for that.
OPTIONALLY: You will need 6 pieces of magnet (8 mm diameter, 3mm thick).
There are 3 magnet holes per side, but two magnets are enough.
Without magnets you can simply superglue the door handle part and the table holder top part together too.
UPDATE: I mirrored the door handle part, in case someone wants to print for door with handle at the left side.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
Tricker
