Simple Rod/Dowel for "Disc golf rack divider for rack or for disc golf bag"

This is meant to connect the divider panels in the original model.  The length is not long enough for a typical bag so, instead, I printed three panels and four rods.  The middle panel has a rod inserted half way from both sides.  It's designed to be a pretty tight fit but I found that a little bit of super glue was required to ensure they don't work their way out while walking the course.  I've played 5-10 rounds with it in my bag and they are holding up.

I printed in PETG, 4 walls, 80% infill, 0.3mm layer height with a 10mm brim.  Due to the height and small footprint, you need to print it very slowly, otherwise the movement of the bed will cause poor print quality in the upper layers.  I'll upload the GCode I used on the Prusa MK3s+ but I turned the speed back to 75% about half way through the print.