Designed for PETG. Don't forget to rescale if you change material to TPU 95A (I recommend to start with a factor of x1.02)
Design allows for more temper-proof installation, because the screws can be contained
Case Dimensions: 80.8mm X 37.0mm X 12.0mm
4mm wall thickness should grant sufficient protection for your tag
Case can be sealed by inserting 205mm of 1.75mm diameter TPU filament
screws are also contained within seal to prevent rust
Tight fit and zero-rattling. You can only get the tag out of the case with a tool. I recommend a pair of angled pincers (see image)
One version for M4 heated inserts, one version for M4 nuts (pause print and insert nuts)
2 to 7 heated inserts (M4, up to 8mm deep) OR 2 to 7 M4 nuts
+ the respective M4 screws
Has a little compartment for the battery replacement wire that comes with every tag. That way you have the tool available when you change the batteries
I was asked to add a version wood screws. It's designed for a screw with a head diameter of 8mm, and 4.2mm body diameter. (+0.2mm tolerance)
You will need two of bespoke screws which will be screwed through the case
geeky.gent
