Winwing FCU to Honeycomb Bravo mounting brackets

I created this model to mount my Winwing FCU to my Honeycomb Bravo throttle. It keeps the FCU rigid and has a 15 degree upward tilt to make it easier to view. 

Print settings:

0.2mm Layer Height

20% infill

3 walls

Print mount on its side, either side is fine. 

Installation:

Unscrew the furthest screws on either side of the top of the Honeycomb Bravo and mount the Left and Right brackets accordingly screwing them back down with the same screws you removed. (The holes on the vertical support should be inward to the holes that mount to the throttle)

Use the screws that came with the FCU (about 27mm long) to mount the FCU to the brackets. I used a washer on the top mounting hole and no washer on the bottom recessed mounting hole.