Tea Light Christmas Trees!

Light up your space with these Tea Light Christmas Trees! Available in three different sizes!

These lovely trees are meant to be printed in vase mode and accommodate space to add a tea light into the trunk of the tree!

The tea light diameter required is 38mm in diameter.

It is recommended that you use the 3mf files provided with the below recommended settings. 3mf files were created in Bambu Slicer so it can be opened in Orca Slicer and Bambu Slicer.

this model is meant to be printed in vase mode.

If you use a different slicer, you should be able to achieve the same effect by using the following settings:

IMPORTANT Printing Instructions:

• Print in vase mode!
• Layer height: 0.2mm
• Bottom shell layers: 25 (That's not a typo. that's twenty five bottom layers. But don't worry. I've optimized the model to not use a ton of filament even with so many bottom layers)
• Wall generator/wall type: Arachne (The print will still work without arachne enabled, but the bottom just won't look quite as thin as the rest of the print)
• Enable "Print infill first"

About

For those who are curious, the filament I used for these trees is Polymaker Panchroma translucent rainbow! That's right! I used the exact same role of filament for all the trees that I printed! Polymaker ftw!

For those who have joined my club at the “Obsessor” tier or have subscribed to my commercial membership on Patreon, prints of this model can be used for commercial purposes.

Feel free to join my discord for additional support, questions, or suggestions!