Ultimate Traxxas TQi controller RAM mount

If you need to mount your phone, camera, or any other device on your Traxxas TQi controller get that model and print it out!

It's a popular mount used for offroad devices, phone holders for bikes, motorcycles, etc.
The ball mount is at 30° angle, allowing you to navigate your RC model freely.

You gonna need some longer screws, hot glue, or any other glue if you want to make it permanently mounted to your controller.
If you decide to use screws, you need to find a set of two 40x4 mm (the original ones are too short). Additionally, two-sided tape between the mount and controller can stiffen out the whole setup.

Print standing on the longest side, minimal supports are required.

Printer parameters:

• material: PETG, or any other strong and elastic material,
• wall loops/perimeters: 8+
• infill: 40%+ gyroid
• supports: YES, on a build plate only
• screws: two 40x4 mm (max length 45x4 mm - if needed)