KYB 48mm Fork Shock Adjuster

A simple tool which uses a slotted ¼" hex bit to adjust the compression clickers on a 48mm KYB shock -  Adjusting them using a screwdriver is often difficult because the bars are in the way.  

There are 2 models here, 1 for standard 25mm bits, and 1 for shorter, but less common 18mm bits.   I used a bit with a face width of 1.1mm (I think this is #2, but not sure)

Print with a pause at 1mm for a layer or two to do multicolor with filament swaps.  It prints best top down.

Insert bit.  you may need to press it in.  if it's loose, use a bit of cyanoacrylate adhesive to retain the bit.

Fusion360 file is included.