iPhone 5/5S/SE (1st gen) screw-on tripod mount 3D Printer File Image 1

iPhone 5/5S/SE (1st gen) screw-on tripod mount 3D Printer File Image 2

iPhone 5/5S/SE (1st gen) screw-on tripod mount 3D Printer File Image 3

iPhone 5/5S/SE (1st gen) screw-on tripod mount 3D Printer File Thumbnail 1

iPhone 5/5S/SE (1st gen) screw-on tripod mount

prochazkaml

February 1, 2022

Description Comments Tags

Description

A simple screw-on tripod mount for the iPhone 5/5S/SE (1st gen).

Requires no screws/nuts to assemble. However, it is recommended to put a bit of foam on both sides, otherwise the phone will be quite loose while in the mount.

I'd also recommend putting a tiny piece of thin foam on one side to prevent it from sliding around.

NOTE: The 3MF preview on this site for this model is broken, since it uses negative volume!

And print with the brim enabled. Please.

Made entirely in PrusaSlicer with cubes and an already available tripod screw model as a negative volume modifier. The license of this model matches the one of the original tripod screw.

License:

Creative Commons — Attribution