Multi-colour Parts - Les Paul Controller for Guitar Hero/Clone Hero/YARG

Loving the Les Paul Clone Hero guitar, thought I would make a few changes to make it even a little fancier with the included .step file from the original creator. 

Guitar Neck (Split version)

Split 2mm off the face of the neck and added individual fret bars. Made the fret pattern align with the seam of the two neck parts to help hide the joint. Note, I also changed the length of the screws here to 40mm for the connecting joint (had a lot of these kicking around).

Headstock Multi-Colour

Version I used saved in Bambu studio format. Added a colour swap at 2mm so the face of the headstock colour change aligns with fretboard. 

Guitar Face Ray Burst

Cause why not? Split it right at the circle pattern, barely noticeable seam when joined. Printed this one with a mix of transparent PETG and solid colours with a fun infill pattern, turned out really neat. The strum side requires supports for printing. I used PLA for the support interface enabling a really clean finish. 

Guitar Face Circle Pattern

Similar goal here, was looking to make a quick pattern that hid the seam. Supports required for strum side.

Strum Bar Plate

Wanted to fancy up the cutout around the strum bar hole. Printed at 0.1mm for a smooth transition. Used thin CA glue to attach, just be careful when doing so as there is not a lot of tolerance in the fitment.