Typhur Sync Gold Dual Protective Sleeve

I've printed the full “cutouts” version in 87A TPU, and while it fit perfectly… there so much stringing. And the bridging was entertaining.

All-in-all…. print any of the variants with big holes in TPU at your own risk.  I have yet to print in PLA/PETG, but I imagine it'll turn out fine.

The “solid” variants (notably don't have the kickstand hole) have top-side notches to allow for grabbing the device to remove it from the case.

Variants

I've made a few variants, some more of a protective case for storage, and others so you can still see the display. 

• cutouts – All features cutout, so it's more of a protective shell.

  • if you print in TPU, hopefully you have better luck with stringing than me!

• nocut – Protective shell, but leaving the holes minimal to reduce stringing. You'll need to manually cut the holes. 

• solid – Solid sleeve, with just the USB port accessible.

• solid screen nocut – Solid sleeve, with the screen not cut through.

  • Manually cut the hole.

  • Or, print with translucent PLA/PETG/TPU, to still see the screen!  

• solid screen cutout – Solid sleeve, with the screen fully cut out.