Gridfinity Stand for Feather ESP32 with Reverse TFT

About

I've got two Adafruit ESP32-S3 Reverse TFT Feather and without any enclosure or stand it is a bit inconvenient to use them, especially if you have a lot of other tools on the messy table :D

Thus I mixed gridfinity bin 1x2x2 from the Gridfinity Master Collection with official Feather Stand but due to the license conflict of both models I just dropped both from ‘remix’ and applied more restrictive license from Gridfinity. Later on I added 1x1x3 remix for a vertical mount.

The bin uses standard gridfinity magnets (6x2 or 6x3 mm).

The white two-side enclosure on the Feather is Adafruit ESP32-S2 Reverse TFT Feather Case (there are multiple models).

Please give a like and post makes and provide comments for further improvements.

Changelog
- 2025.01.19 - added vertical models
- 2024.12.26 - initial release, only horizontal and shifted version

Models
- Flat vs with Railing - is smooth and nice but is not that practical if you for example have a  LiPo battery, which would slip from it, and thus railing comes in with a help (not on the pictures yet).
- Centered vs Shifted - centered looks nice but USB cable can be a problem, so use a Shifted one.
- vertical A and B - vertical A allows attaching the USB cable from the bottom, and B from the top

Print
- vertical versions (gridfinity 1x1) can be printed without supports, but the magnet holes will be a bit ugly
- horizontal versions (gridfinity 1x2) should be printer with supports
- example photos with Devil Design PETG White, 0.2mm layer, 0.4 height, speed profile.
- gcode just for rough print estimation.