November 2, 2022
Description
Replacement rails for an Antec case.
I was repurposing one of my computers to be an Unraid (https://unraid.net/) server, and while moving things around, I broke one of the rails that hold in the hard drives.
I looked at other rail designs, but couldn't find one I liked.
Beyond simply fitting the case, I wanted it to not take screws.
I could not find an existing rail that did both, so I created this rail.
Set the number of vertical perimeters so that the pin is solid plastic.
In my case, this meant increasing the value from 2 to 3 to get a solid pin.
As noted by CircuitGuy in the comments, do use supports when printing.
- Code: https://github.com/AnthonyZ71/antec_case_rail
- STLs: https://www.prusaprinters.org/prints/112341-antec-three-hundred-two-302-35-hdd-rail
This OpenSCAD file makes use of the dotSCAD library (https://github.com/JustinSDK/dotSCAD) and assumes it is installed in the system properly.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
AnthonyZ71
