Might remix later, seems like in cura the bottom wall is a lil thin like I cut too deep with the holes for the tape/glue[bottom] but doesn't seem like it'll be an issue, I'm currently printing it, but I'm pretty confident it should fit the needs of holding a remote.
Instructions:
- Load the Dummy Remote with the Tester into your slicer.
- Change the size of the Dummy Remote [width/depth].
- Scale the tester model around your resized Tester ring.
- Note the scale/resize[width/depth].
- Print the Tester ring, test it's fit around your remote/device.
- ?????
- Profit!
- if it fits apply same scale to the stand/mount. if not, make adjustments, retest.
- Print it!
- Optional; Apply Mounting Tape/Hot Glue/Padding to the slots at the bottom.
- Place/Mount it wherever you like.
- Stand and adore your newly secured remote/device in all of it's glory.
- Gather your friends and family to gaze upon your mounted obscure device.
Link
