September 24, 2025
Description
I DID THIS JUST FOR MYSELF AND FOR A FRIEND, ACTUALLY I DIDN'T REALLY WANT TO SHARE IT, SO I APOLOGIZE FOR ANY FLAWS.
In order for the face to be transparent, but at the same time darkened, it must be printed from transparent plastic with a line width of 0.6-0.7 mm on the first layer (I used PETG) and then a tinting film for cars with a light transmission of 5%
To better lock the led ring, you will need to slightly sand the inner diameter of the two rectangles (there are bumps on the model, follow them).
Orientation of printing parts
Nuts insert here
Screw holders needs to be printed with a brim.
To insert the screw into the holder, you need to sand the two sides of the head. After inserting, I recommend filling the hole with superglue and baking soda so that the screw does not fall out.
Dupont Line 15cm female wires for soldering only arduino or any other wires for soldering direct to components and arduino.
To avoid problems with bending the data type-c cable, I recommend angle adapter type-C female to male.
I thought "style D" was the best option.
Â
License:
Creative Commons — Attribution — Noncommercial — Share Alike
ReedTiger
