The Pavo Pico, Pavo20 and Femto from BetaFPV use the same VTX hole spacing so they are compatible.
Not compatible with the Pavo20 Pro that is larger.
The mount is around 2.8gr (depending on your print settings). The stock version (plastic only) is 1.55gr so it's heavier but compensated by the o4 lite weight.
---
Print instructions:
- Use heat resistant filament (the VTX can reach close to 100degrees)
- No support required
- 3 perimeters
- 0% infill
---
Parts needed:
- 4x M2x20mm
- 4x M2x8mm
- 2x M2x4mm
- 4x M2 nuts
- 4x M2 lock nuts (or standard nuts)
- 4x M2x2.5mm (came with the drone)
- 1x Carbon cross (came with the drone, enlarge the outer hole to M2 size)
---
Instructions:
- Print without any support
- Break away the 4 breakable support in the M2 nuts holes
- Put nuts in place
- Put the carbon cross on top of it and screw it with the M2x2.5 (self tapping)
- Screw the VTX below with the M2x8mm (pay attention the long side of the rubber gromet is toward the top and the USB port is also on top)
- Route the antenna cable
- Screw the camera on the top screw hole using two M2x4mm
- You VTX assembly is ready
- Take your drone and pass the M2x20mm through the body
- Insert the VTX assembly
- Secure it with the M2 (locking) nut
- Attach the data cable
M600
