Snowmote - Case for Cowmote-Based Pubmote

3d printed case for the Pubmote project, a VESC onewheel tilt remote.

Hardware Requirements

• 5 x M1.7 screws
• CowPowerSystems development PCB
• LilyGo T-Display S3 Amoled (1.43in)
• PS5 Hall Joystick
• Battery (this one fits the 51mm x 31.25mm x 9mm holder)

Printing Instructions

Print in your preferred material with as much infill as you like, but here are some print settings recommendations:

• 30%-50% infill, so the large, flat areas are sturdy
• Face down on the bed, so no supports are needed

Assembly Instructions

See GitHub repository for instructions