IKEA Skådis USB Vacuum Pump Holder | T Nut System | No Support Needed

IKEA Skådis USB Vacuum Pump Holder | T Nut System

This custom holder is designed to securely store a USB vacuum pump commonly found on Amazon, often sold in vacuum-sealing kits with blue bags and clips to store filament to keep it dry. The holder is compatible with the T Nut system by @6d6178 for IKEA Skådis pegboards, ensuring a strong and stable attachment.

The design features:

• A compartment for the USB vacuum pump itself.
• Space for the USB cable, keeping your setup organized.
• Slots for up to three clips from the vacuum-sealing kits, ensuring everything is stored neatly in one place.

It uses 2 T Nuts for stability and requires M2.5 screws (M2 screws may work but are untested). Like my other Skadis models, this design prints easily in its provided orientation with no supports needed.

If you'd like to purchase the vacuum pump, you can find this or similar models on Amazon.

✅ Features

• Compatible with T Nut System: Securely attaches to IKEA Skådis pegboards.
• Versatile Storage: Holds USB vacuum pump, cable, and up to 3 clips.
• Support-Free Design: Prints cleanly in the provided orientation.
• Stable and Durable: Uses 2 T Nuts for a strong hold.

📃 Print Settings

• Material: PLA tested, compatible with PETG or other filaments.
• Layer Height: 0.2 mm (other heights also work).
• Supports: None required.
• Hardware Needed: 2 T Nuts (M2.5 screws recommended, M2 may work).

🛠 How to Use

1. Print the holder in the orientation provided in the file, no supports needed.
2. Insert two screws through the holes and attach one T Nut to each screw.
3. Use the alignment guides on the back of the holder to position it accurately on the Skadis pegboard.
4. Tighten the screws to secure the holder (avoid over-tightening).
5. Place the USB vacuum pump, cable, and clips into their respective compartments for organized storage.

For more information about how T Nuts work and how to install them, refer to this link.

📸 Share Your Print

Show me how you’re using this holder! Upload your Make with photos, and share creative ways you’ve implemented it for your workspace.

💡 Feedback Welcome!

Have ideas for improvements or need a different size? Leave a comment or message me, and I’ll do my best to accommodate your request.

❤ Enjoyed This Model?

If you found this model helpful, consider giving it a like! Your support means a lot and helps me create more designs like this.