Recreator 3D Lamp

The build

• print the necessary parts
•  press fit the Y axis aluminum spar in to “base 2.0”

• run wires thru the center of the spar 

•  screw in a m3-16 bolt in to the base flush against the wires

• screw 4 m3-20 screws in to the base in holes 

•  after all of the screws are in, screw on the leveling knobs on to the m3-20 screws

• place some felt pads on the bottom  leveling knobs 

• Bolt the battery pack to the back of the aluminum spar, use the same T nuts used for the recreator, link here: https://www.amazon.com/dp/B0CG4V4NBR?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1 battery pack link here: https://www.amazon.com/outstanding-4-Pack-Plastic-Battery-Closing/dp/B08PCY1M8C/ref=sr_1_34?crid=XEY8GANNVJRY&dib=eyJ2IjoiMSJ9.mw-bnOaOq_0N2ji7hTaOdLa_fWbp8T4BnABS-boF-QCMKOe3ZjTxzOZTo98ZpJeYx-nKhpJObbQ96KpVWv_8D2QldeKxChP-DcRL7gRG9CsC7KeWiFXG-A-kg-J3v488xg5JEldFj7ElgyAfZuYSRPAODuLvD1Z8DTUktruw6xFNx7thqsrZsbCxeap74PVyp-Icydr5AIcC7btrHzAptcEa2awJTQ1gT5KTlwsUuco.c5NHNgyMAjKjPnWC4yP4wU4SXUeFDdo9qxGpPinVWDo&dib_tag=se&keywords=2aa+battery+holder&qid=1737844166&sprefix=2aa+battery+holder%2Caps%2C96&sr=8-34&xpid=BhL4OzIqSptlD I cut off the little lever so it did not stick out so much.

also I just put a piece of electrical tape down the back of the aluminum spar

• I got most of the items from this stem kit the like the wire, lights, switch link here: https://www.amazon.com/gp/product/B086WCVB12/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1 first attached the wires to the light bulb holder I glued in the light bulb holder to the cut in half PET  

• Attach the wires to the light stand. Next, glue the light stand to the top of the PET bottle.

• Pull the wires thru the top of the bottle. Next run two wires thru the lamp shade adjuster you might need tweezers and a small screw driver.

• Next screw in the PET Bottle cap with M1-2. Note that you might need to drill out the holes a bit

PLEASE LEAVE A COMMENT ON WHAT YOU THINK AND IF YOU HAVE ANY QUESTIONS