Ender 3 NG Cable Chain

Cable chain and mounts designed to hold all the wires coming from the toolhead and reverse bowden tube, so you dont have to have it sticking up looking all silly. The main chain design was done by Dani C (https://www.printables.com/model/1135339-drag-chain), and I created the mounts to mount it to the toolhead and base. This design was chosen because it sags very little, unlike other drag chains. It is also designed to clear the frame braces on the top.

IMPORTANT!!!! Make sure you download the correct toolhead mount - one is specifically for those using the sprite extruders.

Hardware

• The base utilizes two M3x8 SHCS and 2 M3 T-nuts
• The toolhead attachment for the sprite uses two M3x12 SHCS
• Toolhead attachment for other extruders uses M3x8 SHCS
• Bowden holder uses one M3x8 SHCS and one M3 T-nut
• One or two zipties of your choice

Quantities - adjust according to your preference

• 4x NG_cable_chain_tube
• 1x Bowden holder
• 1x NG_cable_chain_toolhead_mount
• 17x cable_chain
• 21x cable_chain_clip