EBB42 / xxx42 CAN Bus Board Mount for Galileo 2 Extruder

A mount to use an EBB42-style square toolhead board with the Galileo 2 extruder on the Voron Stealthburner. Compatible with original G2E parts and the original CB-G2 cable gland mount. I've included a modified cable gland mount with slightly looser thread tolerances and a zip tie cutout (green in CAD screenshot). 

xxx42 boards are slightly too large for the rear door on the CB-G2, but using the attached STEP file to create a compatible door shouldn't be too difficult. The CB-G2 cable cover should work but I haven't tested it. JosAr's cable cover from the Galileo 2 repo is what's in use in the photo.

BOM for the pictured setup is mostly the same as the CB-G2. Uses 4 heatsets instead of 2 hex nuts to attach the board to its mount. Hardware for the rear door not listed.

• M3 Heatset Inserts x4
• M3x6 SHCS x4
• M3x6 SHCS or FHCS x1 (for cable cover, should be in your Galileo 2 kit)
• M3x35 SHCS x1
• M3x45 SHCS or M3x50 SHCS x1 (should be in your Galileo 2 kit)
• PG7 Cable Gland
• BTT EBB42 or similar toolhead board

A-drive umbilical strain relief mount that I'm using.