Anycubic Kobra 3 Rear Cable Chain (For Heated Bed)

This model might not be strictly needed to prevent the wires from being damaged as they are pretty beefy, but having all the wires on the printer match is fun!

The design uses 17 ChainLatches, 17 ChainLinks, 1 ChainEnd, and 1 ChainStart.

I only used supports on the starting plate, they were not needed anywhere else. These latch pieces click into place and work much better than the chains I used in previous models. 

To install, remove the back spool holder and unscrew the bolts into the frame. Then sandwich the ChainStart piece between the frame and the spool holder mount and screw it back in. The spool holder should still be usable. The end can be installed using the two M3 bolts that hold the current cable to the heated bed. 

Good luck and happy printing!